Notice: On April 23, 2014, Statalist moved from an email list to a forum, based at statalist.org.
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: st: use13save12
From
Sergiy Radyakin <[email protected]>
To
"[email protected]" <[email protected]>
Subject
Re: st: use13save12
Date
Fri, 21 Mar 2014 19:16:08 -0400
Dear Rochelle,
Steven has pointed you to -use13-, you will find instructions on using it here:
http://radyakin.org/transfer/use13/use13.htm
and a troubleshooting section here:
http://radyakin.org/transfer/use13/use13ts.htm
If your situation is not covered there, kindly let me know.
Importantly, even after installing an additional package (like
-use13-, -use13save12-, etc) you should not expect the built-in
commands of Stata to change their behavior (in your case command
'use'). Read more in the following clarification:
http://radyakin.org/transfer/use13/use13_builtin.htm
Best, Sergiy Radyakin
On Fri, Mar 21, 2014 at 5:04 PM, Steven Nakoneshny <[email protected]> wrote:
> The proper command is -use13-.
>
> On Mar 21, 2014, at 2:20 PM, R Zhang <[email protected]> wrote:
>
>> Dear all,
>>
>> After installing use13save12, I still can't open a stata data that was
>> in 13 version on my stata 12 by issuing command:
>>
>> use mydata13
>>
>> What did I do wrong?
>>
>> -Rochelle
>> *
>> * For searches and help try:
>> * http://www.stata.com/help.cgi?search
>> * http://www.stata.com/support/faqs/resources/statalist-faq/
>> * http://www.ats.ucla.edu/stat/stata/
>>
>
>
>
> *
> * For searches and help try:
> * http://www.stata.com/help.cgi?search
> * http://www.stata.com/support/faqs/resources/statalist-faq/
> * http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/faqs/resources/statalist-faq/
* http://www.ats.ucla.edu/stat/stata/