Re: st: RE: r(1000) error when running xi

[A Loumiotis <antonis.loumiotis@gmail.com>]

Thanks Nick.
I will contact tech support and I will take your advise from now on
and clone official stata commands before I modify them.

The problem occurs when I use -ice- which does not accept factor
variables (and the -ice- code uses xi).

SJ-9-3  st0067_4  . Mult. imp.: update of ice, with emphasis on cat. variables
        (help ice, uvis if installed) . . . . . . . . . . . . . . . P. Royston
        Q3/09   SJ 9(3):466--477
        update of ice package with emphasis on categorical
        variables; clarifies relationship between ice and mi

Antonis



On Mon, Oct 31, 2011 at 2:09 PM, Nick Cox <n.j.cox@durham.ac.uk> wrote:
> Also, -xi:- is not needed in Stata 11, given the introduction of factor variables.
>
> Nick
> n.j.cox@durham.ac.uk
>
> A Loumiotis
>
>
> I get the following error when I run xi:
>
> system limit exceeded - see manual
> r(1000);
>
> I modified a bit xi and measured the length of the local orig and
> found out that the error occurs when the macro length of orig exceeds
> 165198.  I'm surprised because I'm not using Stata/IC where the macro
> limit is 165,200 but I'm using Stata/MP where the macro limit is
> 1,081,511.  Do you know why this is happening?
>
> My version of Stata is the following:
>
> .about
> Stata/MP 11.2 for Windows (32-bit)
> Born 01 Sep 2011
> Copyright 1985-2009 StataCorp LP
>
> Total physical memory:     2097151 KB
> Available physical memory: 1726136 KB
>
>
> *
> *   For searches and help try:
> *   http://www.stata.com/help.cgi?search
> *   http://www.stata.com/support/statalist/faq
> *   http://www.ats.ucla.edu/stat/stata/
>

*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/