On Fri, Oct 16, 2009 at 5:13 PM, Vince Wiggins, StataCorp
<[email protected]> wrote:
> Nick Winter <[email protected]> asks about automation support under MS
> Windows (at least I think he is asking about automation support),
>
>> Is it the case that IC does not support this?
>
> Automation is supported for IC and all other flavors of Stata for Windows.
>
> Because Nick is asking, I can only guess that he has tried and failed to use
> automation under IC. If that is the case, I suspect that he did not start
> Stata with the correct command-line arguments to register Stata as an
> Automation object. See section 3.1 Install Stata Automation object of
>
> http://www.stata.com/automation/
Or Nick has started it with these arguments, but without admin rights, and
Stata didn't say that it can't register without admin rights.
Or it was Stata 9 or earlier where there was no automation mode.
Sergiy
>
>
>
> -- Vince
> [email protected]
>
> *
> * For searches and help try:
> * http://www.stata.com/help.cgi?search
> * http://www.stata.com/support/statalist/faq
> * http://www.ats.ucla.edu/stat/stata/
>
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
