<>
As Maarten says, there are easier ways to do this, but if you insist on it, you probably want to use -ssc d parmest- by
Roger Newson:
***
webuse lbw, clear
glm low age lwt smoke ptl ht ui, family(binomial)
parmest, saving(myfile, replace)
u myfile, clear
keep parm estimate /*
*/stderr z p min95 max95
di in red "`=parm[1]' " %5.4fc `=estimate[1]' /*
*/ " 95%( " %5.4fc `=min95[1]' ", " /*
*/ %5.4fc `=max95[1]' " )," " z= " /*
*/ %5.4fc `=z[1]' " , p= " %5.4fc `=p[1]'
***
HTH
Martin
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Maarten buis
Sent: Freitag, 14. August 2009 19:50
To: stata list
Subject: RE: st: Help with glm command results display
--- Muhammad Riaz wrote:
> I will really appreciate if somebody could help me how to display the
> result of the table in one line, after running glm command, by writing
> a command line in stata.
>
> e.g I want to summarize the table <snip> in one line as:
>
> OR=1.97, 95%(1.34, 0.90), z=3.43, p=0.001
>
> If I get this in one line result, I can copy it to one cell of a table.
> I am runing a glm command with a loop to get these results for many
> variables. it will make it easy to put it in a table.
You probably want to use Ben Jann's -estout-. This will make the table
for you, thus also elimiting the need to cut and paste. To install
-estout- type in Stata -ssc install estout-.
Hope this helps,
Maarten
-----------------------------------------
Maarten L. Buis
Institut fuer Soziologie
Universitaet Tuebingen
Wilhelmstrasse 36
72074 Tuebingen
Germany
http://home.fsw.vu.nl/m.buis/
-----------------------------------------
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
