In the mfx.ado lines 1070- 1075 is where the warning message is
generated and in line 1144 there is a local that specifies those
variables.
Supposedly this is the line, I am not really sure how to change it and
make it work.
Cheers
Manos
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Richard
Williams
Sent: 20 July 2007 21:46
To: [email protected]; [email protected]
Subject: Re: st: -warning: variables in at() list not found in model
after mfx or mfx2
At 02:31 PM 7/20/2007, Mirko wrote:
>Yes, the problem really is the number of characters. Unfortunately in
>my original model, the number of characters is doomed to exceed 244.
>Of course, I could easily rename all the variables, and run the
>-regoprobit models again (I have more than one to re-run).. However,
>that would take a couple of days...Maybe Manos is right and a
>modification of the ado file of mfx or mfx2 would do it. Is that
>feasible?
>Mirko
The warning is being generated by -mfx-, which -mfx2- calls. -mfx.ado-
is a big program, and just skimming through it I don't see anything
obvious. If it is a bug, as opposed to just being an inherent
limitation, hopefully StataCorp will fix it.
-------------------------------------------
Richard Williams, Notre Dame Dept of Sociology
OFFICE: (574)631-6668, (574)631-6463
HOME: (574)289-5227
EMAIL: [email protected]
WWW: http://www.nd.edu/~rwilliam
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/