Re: st: Adding a -constraints- option

[Paul Millar <paul.millar@shaw.ca>]

Are these stand-alone commands or post-estimation commands?  If they are 
stand-alone you can just add another option on the command line for the 
constraint.  If it is a post-estimation command you may not necessarily be 
able to pick it up from the estimation command (cnsreg does not leave it 
behind), so once again you will have to add it as an option and the user 
will have to re-enter it.

- Paul


At 12:11 PM 22/03/2005, you wrote:

> This question may be too vague or too broad, but...
>
> There are some user-written commands I would like to add the -constraints- 
> option to.  For somebody who is not the greatest programmer in the world, 
> is this likely to be a formidable task?  Or just a few lines?  Thanks for 
> any tips or sample code.
>
>
>
> -------------------------------------------
> Richard Williams, Notre Dame Dept of Sociology
> OFFICE: (574)631-6668, (574)631-6463
> FAX:    (574)288-4373
> HOME:   (574)289-5227
> EMAIL:  Richard.A.Williams.5@ND.Edu
> WWW (personal):    http://www.nd.edu/~rwilliam
> WWW (department):    http://www.nd.edu/~soc
>
> *
> *   For searches and help try:
> *   http://www.stata.com/support/faqs/res/findit.html
> *   http://www.stata.com/support/statalist/faq
> *   http://www.ats.ucla.edu/stat/stata/
*
*   For searches and help try:
*   http://www.stata.com/support/faqs/res/findit.html
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/