Notice: On April 23, 2014, Statalist moved from an email list to a forum, based at statalist.org.
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
st: oaxaca twofold decomposition
From
Chiara Mussida <[email protected]>
To
statalist <[email protected]>
Subject
st: oaxaca twofold decomposition
Date
Fri, 25 May 2012 16:33:52 +0200
Dear All,
I estimated an Oaxaca model by using the twofold (explained vs
unemplained decomposition) with Stata 11.2. Command:
qui regress lwage $x if fem==0
estimates store male
qui regress lwage $x if fem==1
estimates store female
oaxaca male female, wei(1)
where fem==0 is my reference group.
I tried doing the same with Stata ver 12.1, but I did get an error message:
"variable male not found". The sintax is probably changed with this
new version. I looked at the help but I dod not find a similar command
to get my twofold Oaxaca.
Any suggestions,
Thanks
Chiara
--
Chiara Mussida
PhD candidate
Doctoral school of Economic Policy
Catholic University, Piacenza (Italy)
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/