Notice: On April 23, 2014, Statalist moved from an email list to a forum, based at statalist.org.
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: st: results viewer not outputting from the do-file editor
From
Maarten Buis <[email protected]>
To
[email protected]
Subject
Re: st: results viewer not outputting from the do-file editor
Date
Wed, 16 May 2012 09:17:24 +0200
On Wed, May 16, 2012 at 3:24 AM, Christopher Bowie wrote:
> I am relatively new to using Stata (version 11.1) <snip>
> Recently whenever I run a command out of a do file the viewer shows only the
> output
>
> run "C:\Users\cjb243\AppData\Local\Temp\STD00000000.tmp"
>
> If attempting to create tables none show up and when cases are being dropped
> etc no output of the number of new or removed observations shows up.
Stata has two modes of executing a .do file: run and do. run won't
show the output, as you noticed, while do will show the output. To run
a do file you press the second botton from the right on the toolbar.
To do a .do file you press the last bottom on the toolbar.
Hope this helps,
Maarten
--------------------------
Maarten L. Buis
Institut fuer Soziologie
Universitaet Tuebingen
Wilhelmstrasse 36
72074 Tuebingen
Germany
http://www.maartenbuis.nl
--------------------------
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/