Bookmark and Share

Notice: On April 23, 2014, Statalist moved from an email list to a forum, based at statalist.org.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: st: Followup: inverting a stored table of regression results - then exporting to a cvs/excel file


From   "Ben Hoen" <[email protected]>
To   <[email protected]>
Subject   RE: st: Followup: inverting a stored table of regression results - then exporting to a cvs/excel file
Date   Fri, 5 Nov 2010 13:43:21 -0400

Perfect.  Thanks!

-----Original Message-----
From: Ben Hoen [mailto:[email protected]] 
Sent: Friday, November 05, 2010 1:17 PM
To: '[email protected]'
Subject: st: Followup: inverting a stored table of regression results - then
exporting to a cvs/excel file

You are so right.  My apologies...

Thank you Eric!

If anyone is still tuning into to this post I do have a follow up question:

Let's say I do not know how many groups I have delineated in levelsof, but
needed to create code to break the table if necessary.

I figure, I want to create a local macro of the number of groups and then I
can create an if/then step as is needed.  I am sure one can do this, but I
was not able to figure it out.  Do you know how?

Thanks Guys,

ben

-----Original Message-----
From: Ben Hoen [mailto:[email protected]] 
Sent: Friday, November 05, 2010 11:51 AM
To: '[email protected]'
Subject: st: Followup: inverting a stored table of regression results - then
exporting to a cvs/excel file

Thanks Nick and Maarten!

As if it's a Rosetta stone, I will have to go through your coding and make
sense of the steps.  Many new commands to learn...

I did run your code Nick and it came out perfect.

Best,

Ben
 
Ben Hoen
LBNL
Office: 845-758-1896
Cell: 718-812-7589
[email protected]

==========================


© Copyright 1996–2018 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   Site index