<>
Also note -ssc d cf2-:
*******
capt which cf2
if _rc ssc inst cf2
sysuse auto, clear
replace mpg=3 in 3
tempfile temp
save `temp', replace
sysuse auto, clear
cf2 _all using `temp', verbose
*******
HTH
Martin
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Kaulisch, Marc
Sent: Montag, 16. November 2009 19:52
To: [email protected]
Subject: st: cf output id and not obs
I would like to use the cf command to reproduce changes in the dataset done
manually.
This command works fine in general.
. cf _all using "data.dta", all verbose
The output looks like
"ep15BN15_4: 1 mismatches
obs 265. 2009 in master; . in using"
I would like to get an output that is not giving out the number of
observation but the respective id (stored in var "id"). Of course I could do
a
. display id[265]
But with hundreds of changes this is rather an enourmous task.
Any ideas?
P.S.: I am confused to get an error message r(9) - is that the correct
behaviour? The output looks good...
Thanks
Marc
iFQ
Institut für Forschungsinformation und Qualitätssicherung
Godesberger Allee 90
53175 Bonn, Germany
Tel.: *49 - 228 - 9 72 73 - 25
Fax: *49 - 228 - 9 72 73 - 49
E-mail: [email protected]
www.forschungsinfo.de
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
