-noconst- is not a command, rather seems to be an option to -ivreg- (btw,
say if you use a -version- other than 10...), so it must be on the line of
the -ivreg- command. If necessary, use ///...
-parmest- should then go on the next line...
HTH
Martin
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Diana Eastman
Sent: Wednesday, October 29, 2008 10:20 PM
To: [email protected]
Subject: st: Error Message
Hi all,
I am getting the following error message when I run a portion of code:
. noconst parmest, saving(eq2, replace)
unrecognized command: noconst
r(199);
Code below:
ivreg D.s2 (D.lp23 D.lp13 L.D.s2=L(2/3).s2 D(0/1).(a b c)) D(1).(x y z),
noconst parmest, saving(eq2, replace)
Any idea why this command is unrecognized?
Thank you in advance
Diana M. Eastman
Greylock McKinnon Associates
Cambridge MA, 02142
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
