This message points to conflicting names for -tempvar-s which are Stata`s
responsibility, not yours. Have you tried to shut down Stata and restart
(save all important work first)? These events (name conflicts) occur about
once a month for me...
HTH
Martin
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of jill jim
Sent: Saturday, September 20, 2008 11:38 PM
To: [email protected]
Subject: st: For help on outreg
Dear statalist,
I met a problem when using outreg after running a simple regression. For
example
reg lnpay female age
outreg female age using reg1, se bdec(3) rdec(3) sigsymb(***, **, *) 10pct
coefastr ctitle(I) replace
a message shows up "variable __00000E not found". In fact, I did not even
use or have variable _0000E.
Then, if I keep running the same outreg command as above, another message
"variable __000005 not found" or "variable __000006 not found" comes out.
However, after several times, it worked and gave the result at reg1.out. It
is just very annoying, and I was not able to run in do file since it would
stop due to the messages.
the more variables I included in the regression, the more messages I got,
the more runs I have to do untile get the result.
Did I do something incorrect? Please help me out. Many thanks.
Lin
__________________________________________________________________
Looking for the perfect gift? Give the gift of Flickr!
http://www.flickr.com/gift/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
