 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]
Re: Re: st: new problem with table display
I was trying to avoid the text string because I would have to change a lot
of the programming to accommodate that. But, I think a compromise is to
keep the program using the ids as doubles until just before I print the
tables and then change the type of to a string at the end. I'll try that
and let folks know if there are unanticipated problems with that route.
--On Wednesday, October 31, 2007 5:21 PM +0000 n j cox
<[email protected]> wrote:
Michael Blasnik and Maarten Buis have already supported
my earlier suggestion that you create a string version
of your identifier.
In terms of the specific problem below, -capture- alone
is going to eat all output, including but not only errors.
-capture noisily- may be what you are looking for.
Jennifer S. Earl
I tried putting capture in front of the bigtab command, but that oddly
resulted in no output whatsoever, even when there were known errors that
should have printed.
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*********************************
Jennifer Earl
Director, Center for Information Technology and Society
Associate Professor of Sociology
University of California, Santa Barbara
Santa Barbara, CA 93106-9430
P: (805) 893-7471
F: (805) 893-3324
*********************************
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/