|
[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]
st: RE: RE: accessing results of nlcom repeatedly
From |
"Feiveson, Alan H. (JSC-SK311)" <[email protected]> |
To |
<[email protected]> |
Subject |
st: RE: RE: accessing results of nlcom repeatedly |
Date |
Thu, 28 Jun 2007 10:52:04 -0500 |
Marrten - Thanks. I'll make sure I watch my e's and r's from now on.
Al
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Maarten Buis
Sent: Thursday, June 28, 2007 10:46 AM
To: [email protected]
Subject: st: RE: accessing results of nlcom repeatedly
--- Feiveson, Alan H. (JSC-SK311) wrote:
> Hi - In Stata 9, it appears that after fitting a model and running
> -nlcom- the only way to access the results is to use the "post"
> option, which then destroys the original matrix of coeffcients and
> covariance matrix. So if I wish to run -nlcom- more than once while
> accessing the results each time, I have to refit the original model
each time.
You don't have to use the post option, without the post option -nlcom-
stores the results in r(b) and r(V) (instead of e(b) and e(V)).
Hope this helps,
Maarten
-----------------------------------------
Maarten L. Buis
Department of Social Research Methodology Vrije Universiteit Amsterdam
Boelelaan 1081
1081 HV Amsterdam
The Netherlands
visiting address:
Buitenveldertselaan 3 (Metropolitan), room Z434
+31 20 5986715
http://home.fsw.vu.nl/m.buis/
-----------------------------------------
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/