Hi,
Ok, thanks all. I found the packages and install all three of them and hope
that at least one will fit my needs.
Thank you, best regards,
-Hendri.
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of
> Michael Blasnik
> Sent: vrijdag 4 mei 2007 16:17
> To: [email protected]
> Subject: Re: st: Write output to file
>
> Don't use -outreg- it is no longer supported and has far
> fewer capabilities
> than -estout-, or even -outreg2- for those who preferred that syntax.
>
> Use -findit- or -search- from within Stata and follow the
> instructions for
> installation
>
> Michael Blasnik
>
> ----- Original Message -----
> From: "Dirk Nachbar" <[email protected]>
> To: "Hendri" <[email protected]>
> Cc: "statalist" <[email protected]>
> Sent: Friday, May 04, 2007 9:51 AM
> Subject: Re: st: Write output to file
>
>
> Hendri
>
> check outreg for output
> http://ideas.repec.org/c/boc/bocode/s375201.html
>
> On residuals from logits, there is no straightforward
> interpretation for them
> since they are not normally distributed. You can standardize
> them by dividing
> y-yhat by sqrt(yhat(1-yhat)), where yhat is the prediction,
> and then check the
> mean and SD.
>
> Dirk Nachbar
> and/or recorded for legal purposes.
>
> *
> * For searches and help try:
> * http://www.stata.com/support/faqs/res/findit.html
> * http://www.stata.com/support/statalist/faq
> * http://www.ats.ucla.edu/stat/stata/
>
>
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
