Hi all,
I want to constraint the cut points (four in total) in an ordered Probit
model. Apparently, the oprobit command does not allow you to do that. I
am trying to use the linest command, but I don't know how to set up the
restrictions. Has anybody done it before? I will appreciate any
suggestions you can give me that would spare me from having to program
the ML estimation.
Thanks in advance,
Italo
--------------------
This email message is for the sole use of the intended recipient(s) and
may contain privileged information. Any unauthorized review, use,
disclosure or distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and destroy all copies
of the original message.
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
