Statalist The Stata Listserver


[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]

Re: st: gllapred command


From   "Anders Alexandersson" <[email protected]>
To   [email protected]
Subject   Re: st: gllapred command
Date   Mon, 18 Sep 2006 15:54:35 -0400

Which dataset in the GLLAMM manual do you refer to? Can you reproduce
the problem with that dataset? The trace option of glamm is described
in the GLLAMM manual on pages 20, 35-37, and 95-96. The trace option
can help, e.g., to monitor convergence.

Anders Alexandersson
[email protected]

On 9/18/06, Prathiba Natesan <[email protected]> wrote:
Yes, I did run the gllapred immediately after gllamm. I tried running
the commands from the GLLAMM manual in the exact same order for
another data set. That is where I got stuck. The gllamm command I used
was
gllamm gender i1 i2 i3, nocons link(logit) fam(binom) i(id) eqs(id)
w(wt) constr(1) frload(1) adapt
followed by the gllapred command gllapred nscore, u
I will try using the trace option to see if it points to any error.
Meanwhile, could you tell me what the error could be?


On 9/18/06, Anders Alexandersson <[email protected]> wrote:
> Did you use gllapred immediately after gllamm? What gllamm syntax did
> you type? Can you reproduce the problem on dataset provided by
> StataCorp? Does running your gllapred command with trace on help to
> narrow down the problem?
*
*   For searches and help try:
*   http://www.stata.com/support/faqs/res/findit.html
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2024 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index