Also, to paste several lines in the Stata command window (under Windows), use
shift+insert.
rafal
Quoting Terra Curtis <[email protected]>:
Cameron,
You can just highlight the lines you want to run in the do-file editor and
click on the run button.
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Munro, Cameron
Sent: Thursday, October 13, 2005 9:24 AM
To: [email protected]
Subject: st: Running segments from a do-file
Is there a way to run just a part of a do-file without the whole lot? What I
typically do is /* */ out everything but the parts I want. What I'd really
like to do is cut and paste a few lines into the Stata command window and
run them. But it seems (at least in Windows) you can only run single-line
commands at a time in the command window.
Cameron.
--------------------
This email message is for the sole use of the intended recipient(s) and may
contain privileged information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
contact the sender by reply email and destroy all copies of the original
message.
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
================
Rafal Raciborski
Graduate student
Department of Political Science
Emory University
301 Tarbutton Hall
1555 Dickey Drive
Atlanta, GA 30322
404-378-9826 (home)
[email protected]
http://www.roofoos.net/
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
