I will try. Thank you, Richard.
Warm regards,
Maoyong Fan
University of California, Berkeley
>At 01:22 PM 5/28/2004 -0700, Maoyong Fan wrote:
>>Dear Friends,
>>
>> I noticed that the Stata program will automatically stop when the
>> dataset is empty after deleting the missing value and give out the wrong
>> information: __0000001 not found.
>>
>> In my program, I need to run many programs on the same dataset,
>> so I open the original dataset many times in a big program. Every time I
>> drop some variables and observations, the whole program is stoped if one
>> of the dataset after selection is empty.
>>
>> I wonder if there is some command which can force the program to
>> go on even if the dataset is empty in this subprogram after selection.
>
>The -capture- or -confirm- commands, or the -nostop- option on the -run-
>and -do- commands might help you out.
>
>-------------------------------------------
>Richard Williams, Notre Dame Dept of Sociology
>OFFICE: (574)631-6668, (574)631-6463
>FAX: (574)288-4373
>HOME: (574)289-5227
>EMAIL: [email protected]
>WWW (personal): http://www.nd.edu/~rwilliam
>WWW (department): http://www.nd.edu/~soc
>
>*
>* For searches and help try:
>* http://www.stata.com/support/faqs/res/findit.html
>* http://www.stata.com/support/statalist/faq
>* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
